FL-IH-BIL
GTR Billet Induction Heating Furnace
GTR series through-heating line for round and square billets, with pyrometer control, hot and cold reject gates and press synchronisation.
Read More →
Induction Heating Systems · FL-IH-END
Induction Bar End Heating Machine for Upsetting and Forging
Heats only the section to be formed — hand tools, axles, anchor bolts and eye bolts — cutting energy per part sharply versus full-length heating.
- Far lower energy per part than through-heating
- Heated-length repeatability ±10 mm
- Recipe storage — one-touch changeover between part numbers
- Manual, magazine or robot feed
- Compact cell for a small workshop footprint
- Bar diameter
- 8 – 120 mm
- Heated length
- 30 – 600 mm, ±10 mm repeatability
- Heating temperature
- Up to 1,250 °C
- Power supply
- IGBT, 50 – 500 kW
- Cycle time
- 8 – 60 s depending on section
- Feed
- Manual, magazine or robot
- Control
- Pyrometer closed loop with recipe storage
Product Details
When only one end of a bar is upset, heating the whole bar wastes most of the energy and distorts the rest of the part. An end heater applies power over a defined length, held to a repeatable tolerance, so the transition zone is consistent from part to part.
Typical applications are hand tool forging, anchor and eye bolts, axle shafts, agricultural tines and reinforcing bar couplers. Feed can be manual with a foot pedal, semi-automatic with a magazine, or fully automatic with a robot pick-and-place.
Energy per part is a fraction of through-heating the same bar, and cycle time is short enough to feed a press directly without a buffer.
More Induction Heating Systems
FL-IH-HRD
Induction Hardening Machine
Scan or single-shot hardening with servo traverse, integrated quench and closed-loop power control — repeatable case depth on shafts, gears and rails.
Read More →FL-IH-QT
Induction Quenching & Tempering Line
In-line hardening plus tempering in a single continuous pass — for steel strand, PC bar, drill rod, grinding rod and tube, with per-zone temperature control.
Read More →FL-IH-PIP
Pipe & Plate Heating Line
In-line heating for pipe coating, bending, normalising and plate hot-forming, with continuous throughput and zone temperature control.
Read More →Tell us what you melt.
Send your alloy, target output per hour, working hours and grid voltage. You will get a capacity recommendation, a plant layout and a firm quotation — normally within three working days, no obligation.